Sisca
Member
- Messages
- 37
I'm using the Vault Bunk Bed from the blueprint set and I've used one of the assignable markers - Sleep Surface (Counts as Bed) - to mark the top bunk as usable. The markers are being counted as beds but as soon as the bed count increments the marker itself disappears from view.
I have the show markers in WS mode toggle on but I've tried switching it off and back on with no change.
I tried the new command (cqf kgsim_cpmanager findobjects beds ) and it shows me a quest marker to where the marker is but nothing I do lets me highlight it. Can't even select it in the console to disable it.
This is a problem since I need to move a couple of those markers now that I've done some tweaking to the layout of an area.
EDIT: Ok just found that for some reason the markers are NOT going to the current layer. Did show all layers and they're now showing up.
I have the show markers in WS mode toggle on but I've tried switching it off and back on with no change.
I tried the new command (cqf kgsim_cpmanager findobjects beds ) and it shows me a quest marker to where the marker is but nothing I do lets me highlight it. Can't even select it in the console to disable it.
This is a problem since I need to move a couple of those markers now that I've done some tweaking to the layout of an area.
EDIT: Ok just found that for some reason the markers are NOT going to the current layer. Did show all layers and they're now showing up.
Last edited:
