Issues with Vault Tech interior plots & power supply?

[Citadel97501]

Hello all, I was just playing through vault 88 in my current playthrough and used it to set up a crap load of interior plots, and I noticed that the vast majority of the plots from that mod float. IE just using Atrium floors and what not but a very large number of these plot pieces have beds floating a few inches off the floor. In addition to this issue I noticed that I needed massive numbers of the SS power switches for this vault as unless I added one nearby the plots didn't get power. It seems the power doesn't spread much past 12 squares (6 interior plot measurements).

 

[Samutz]

The atrium floors have their power station snap points (what the interior plot snap to) slightly higher than the rest of the of the vault wall pieces. The interior plots have additional snap points adjusted to accommodate this, but they tend to default to the higher position first and require you to look down a bit to make them snap lower. It's easier to do get them to align correctly with the Place Everywhere mod.

If I remember correctly, I gave the Vault Power Grid Relay in Vault-Tec Tools a pretty generous radius for power output. Although in my testing, I placed one to provide municipal power to the vault walls and then used the default DLC vault power conduits placed around the vault to power plots and lights. One usually covered several plots, including plots on above and below floors. There are also mods that increase the radius of the default conduits.